EDO 2425 FLOATS

These are stock floats with data plates and are off an early 180. Struts could be cut down to shorter for Stinson or other. There are pump out fittings but I think a couple of the plastic cups need replacing. There are dual water rudders; streamline tie wires on the front and cables on the rear. I forget what  the horizontal diagonals are. The front bumpers are off and need replacing.

 

 

 

 

 

 

 

 

 

I think the pictures show most of the blemishes. They were reasonably tight when I last used them about 10 years ago because I left it floating for a week at a time with very little pump out required.

 

Peter 705 877 8404

Peterc at pipcom.com   ( change to @)