IGNU Maintenance

Cyl head temp not working. Re routed wire, connector cleaned

Replaced damaged glass fuse holder at regulator with automotive resetting fuse

Added shielding to chaffed parts of generator output to regulator cable and tied off

Rotated exhaust stacks to provide more clearance from mount.

Added slack to both throttle cables to allow use of throttle stops.

Re-synched carbs

Dynamicly balanced prop

Repaired enlarged holes in four lower cowl mounting points and added large diameter spacers, rubber washers and metal fender washers.

Added L bracket to right side of gear box as tie point for oil line.

Added heat shield to oil line and tied it further from exhaust.

Tied off chaffed mag grounding cable near stator.

Tied down loose ignition module due to broken mounting bracket (needs replacing)

Replaced oil and coolant overflow tubes and re-routed to eliminate kinks.

Fuel line from engine to shut off replaced, re-routed and shielded

Trimmed flap pin stops to enable use of third notch in flight (worked fine on the ground!)

Protective coating on rusted hardware.